12:30 AM      No comments
By Rebecca Baker


The battery characteristics play an important role when selecting the correct one for your particular application. Do you need a high current for short bursts to start a vehicle or are you going to have high and frequent discharges to power accessories such a radio or pump on a boat or RV? The following article will discuss more on the topic the difference between starter and deep cycle types of automotive batteries Oregon and CCA and RC power rating explained.

By performing regular care and maintenance on your battery year round, you should be able to catch those batteries before cold weather sets in and the before the battery leaves you stranded in four feet of snow and ice. Testing and taking care of the maintenance of your battery only requires a little bit of time and a few tools.

Doing so will greatly shorten the life of the battery and if deep discharged will only provide 30 -50 discharge cycles. Once your vehicle is started and running, the alternator takes over the task of powering up the vehicles electrical system and keeping the battery at a full charge. Deep cycle batteries are constructed with thicker plates and are designed to be deep discharged time after time without shortening the life of the battery.

This means no smoking. Batteries produce a hydrogen gas, which is highly flammable and because batteries contain sulfuric acid, you want to do what you can to protect your eyes from sulfuric acid getting in them. If you get sulfuric acid on your skin, mix baking soda and water and apply to the area. This will neutralize the acid and prevent additional damage or burns to your skin.

The two power ratings found on an automotive starter battery are CCA and RC. These power ratings are important factors when selecting the correct replacement battery for your car or truck and should not be overlooked. Cold Cranking Amps - This is the amount of current (measured in amps) battery can "crank out" for 30 seconds at 0 degrees Fahrenheit (-18 degrees Celsius).

Dissolving baking soda in warm water is used to clean the battery. Wet the case and agitate with a nylon bristle brush, then rinse well with plain water. Batteries appear in a lot of dissimilar sizes. When restoring a car array, make sure you prefer the accurate size for your automobile When it comes to car batteries, always keep in mind that superior is not inevitably better.

Never use a battery with a CCA rating lower than your vehicles specified rating! Check your vehicle owners manual if in doubt or check with a salesperson at your local auto supply shop. Reserve Capacity - This is the length of time in minutes that a battery can provide 25 amps at 80 degrees Fahrenheit (26.7 degrees Celsius). The reserve capacity of a battery is important should the alternator fail as the electrical system in your vehicle will need to be maintained.

You will be replacing the fluid with a new one made from Epsom salts and distilled water, do not use tap water. Add this fluid to each cell using a funnel then replace the caps or plug holes. Shake the battery the best you can; they are heavy so be careful. This will ensure the fluid is properly mixed in among the cells. This Epsom salt solution will be the new fluid.




About the Author:



0 commentaires:

Post a Comment

Popular Posts

Recent Posts


Unordered List

Text Widget

Blog Archive